Didactum Dry Contact devices
Didactum`s dry contact units offer two states:
- „normal“ - dry contact is in normal state
- „alarm“ - dry contact is in alarm state
If needed, the inversion of dry contact is defined by setting a status field ctlDiscretReversed (default is "0“).
The port number of each dry contact input is shown in field ctlDiscretHardwarePort.
To check available dry contact inputs just use
$ snmptable -Ci -Cb -v2c -cread 192.168.0.193 DIDACTUM-SYSTEM-MIB::ctlDiscretsTable
SNMP Table:
SNMP table: DIDACTUM-SYSTEM-MIB::ctlDiscretsTable